Exclusive, super-micro abrasive technology Ultra-fast cutting removes 1200 grit or finer sanding marks Super-micro abrasives leave best in class finish Great for removing scratches, defects, acid rain and severe swirls/holograms Formulated for use by Hand, DA Polisher, or Rotary Buffer, and is body shop safe.

Applying Meguiar’s M105 Ultra Cut Compound

Method 1: Applying by hand Distribute a small amount of compound on a Meguiar’s Soft Foam Applicator Pad Work in a 1-2 square foot area in a circular pattern, making 4-5 overlapping passes per section to ensure that the compound has been properly applied. Without letting the product dry, use a fresh, clean Meguiar’s Supreme Shine Microfiber Towel to remove the residue. Flip your towel to a clean side for a final wipe. Reapply the compound if you didn’t remove the defects with the first application. Apply in sections like this over the vehicle.

Method 2: Applying by Meguiar’s MT300 Dual Action Polisher Attach Meguiar’s Red Foam DA Cutting Disc to the MT300 DA Polisher. Dispense a small amount of the compound directly onto the pad. Set the MT300 DA Polisher speed between 4,800-5.800 OPM’s. Work in a 2’ x 2’ section applying 2 to 3 overlapping passes with moderate pressure, followed by light pressure for following 2 passes. Do not let product fully dry. Wipe off the residue with a fresh, clean Meguiar’s Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe. Reapply the compound if you didn’t remove the defects with the first application. Apply in sections like this over the vehicle.

Method 3: Applying by Rotary Buffer Work one section at a time. Set rotary buffer to approximately 1000-1500 RPM’s. Dispense a small amount of the compound directly onto the paint and begin working in a 2’ x 2’ area with overlapping passes. Continue working until a light film remains. Wipe off residue before the product dries with a fresh, clean Meguiar’s Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe. Reapply the compound if you didn’t remove the defects with the first application. Apply the in sections like this over the vehicle.